Electronic control fuel injection system (Common rail type) 1E-373 Step Action Value YES NO 5 1. Turn the key switch to “OFF”. 2. Disconnect the engine oil pressure sensor connector. 3. Short the engine oil pressure sensor connector signal terminal to the ground terminal using jump cable. 4. Turn the key switch to “ON”. 5. Check the value for “Engine oil pressure sensor” using scan tool. Is the “Engine oil pressure sensor” less than the specified value? 0V Go to Step 9. Go to Step 6. 6 1. Check the signal circuit between ECM and engine oil pressure sensor for short circuit to the power supply circuit or ignition power supply circuit, using breaker box or DMM.
Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. Important: If the engine oil pressure sensor circuit is shorted to the power supply circuit, the sensor may be broken. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 13. Go to Step 7. 7 1. Check for followings in the signal circuit between ECM and engine oil pressure sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance 2.
If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 13. Go to Step 8.