hitachi — DTC: P0523 (Flash code 295) Engine oil pressure sensor fault (high voltage fault, short to power supply, ground short)

1E-376 Electronic control fuel injection system (Common rail type) About engine oil pressure sensor Characteristics of engine oil pressure sensor The output voltage of engine oil pressure sensor changes according to the engine oil pressure. The scan tool with CAN communication displays a fixed value when the value exceeds the threshold voltage. Therefore, judge as it is more than the threshold value if the value of 0 kPa (0 psi) or 1088.5 kPa (157.9 psi) is not changed. When error occurs, error value (1016 kPa {147.4 psi}) is displayed. The following illustration shows the correlation between physical value and voltage displayed in the scan tools with CAN communication.

Tech2 and scan tools with KW communication can display both physical value and voltage. 1 2 3 (V) TSWG0164 4.85 Name 1. Sensor ground 2. Sensor signal 3. Sensor power supply 0.496 0 1088.5(157.9) kPa(psi) TSWG0202 Step Action Value YES NO 18 1. Check for followings in the ground circuit between ECM and engine oil pressure sensor, using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance 2. If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 13. Go to Step 9.