hitachi — DTC: P0606 (Flash code 51/52) CPU fault

Electronic control fuel injection system (Common rail type) 1E-383 DTC: P0606 (Flash code 51/52) CPU fault Description of circuit The internal part of the ECM consists of ROM, EEPROM, CPU, and Sub-CPU, which perform data storage, data clear and various controls. The ECM sets the DTC when the CPU fault or Sub- CPU fault inside the ECM is detected. Action taken when DTC is set Trouble is displayed on the monitor of the machine or diagnosis lamp comes on. Back-up mode Main trouble symptom • Specified back-up value Output lowering SUB-CPU stops control Limited injection amount 1 Preconditions when DTC is set 480 msec or more has elapsed after key switch ON.

Key switch input power supply voltage is higher than 16 V. Recovery from failure Refer to “List of diagnostic trouble code” and “About recovery from failure” in this section for recovery from failure. DTC set condition Sub-CPU detects main CPU fault in 10 msec after key switch ON. RUN-SUB pulse does not change for 20 msec or more. The conditions to clear the MIL/DTC The present trouble turns to history trouble when the condition is out of the range from DTC set condition (recovery from failure). The diagnosis lamp will go off after the code turns to history trouble and the key switch is turned “OFF” then “ON” again.

Using the scan tool, or memory clear switch and diagnostic switch operation enables to clear DTCs. Step Action Value YES NO 1 Perform the OBD system check. Is the procedure completed? — Go to Step 2. Go to “OBD system check”. 2 Check the DTC again. 1. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 2. Turn the key switch to “OFF” for more than 10 seconds. 3. Test run with the “Preconditions when DTC is set”. 4. Check the DTC. Is DTC P0606 detected? — Go to Step 3. Go to “Diagnostic aid”. 3 Is EMPS available? — Go to Step 4. Go to Step 5.