hitachi — Diagnostic procedure

Electronic control fuel injection system (Common rail type) 1E-35 5. Press the function key [F0] or bring the cursor to [F0: Engine] by operating the selection keys ( ). And then, press the [ENTER] key. TSWG0093 8. The following illustration shows the state in which the Tech2 is waiting for communication with the machine controller. If the softkey “Next” is pressed with the ignition key in “OFF”, this display will stay forever. (State of communication disabled) However, turning the ignition key “ON” to “START” in this condition will place the unit in the waiting state for communication. TSWG0091 6. Select Powertrain (Eng.

name) on the “Vehicle Identification” screen and press the [ENTER] key. TSWG0092 7. The items chosen in steps 3 to 6 are shown in the Message Area display section. If the identification of the machine is OK, turn the ignition key “ON” to “START” and press “Next” by following instructions given on the screen. 9. Once the communication is established, the unit will show the part No. and DDI (Diagnostic Data Identification) (which varies from a system to another). Press the softkey “Confirm” and go on to the application. If any mistake was made in the selection of the vehicle type, despite that the communication is enabled, a message to that effect will appear flashing.

If that is the case, check the vehicle type again and redo the operation from step 1. TSWG0122 Note: If you make any mistake, pressing the [EXIT] key will return you to the “Main Menu”.