Electronic control fuel injection system (Common rail type) 1E-401 Breaker box inspection procedure Perform the inspection in the following procedure if there is such an instruction to use breaker box in the step. After inspection, return to the diagnostic step. Name 1. Breaker box 2. DMM Step Action Value YES NO 16 Check if DTC is not detected again. 1. Connect all the harnesses. 2. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Turn the key switch to “OFF” for more than 10 seconds. 4. Test run with the “Preconditions when DTC is set”. 5. Check the DTC. Is the procedure completed?
— Go to Step 17. — 17 Check if DTC is detected. (DTC for entire engine control) Is DTC detected? — Go to the related “Inspection method by DTC”. Verify repair. Step Item to be checked Inspection method Measuring condition Terminal No. Normal value Abnormal value 6 Short circuit to ground Resistance measurement • Remove the meter connector. • Key switch “OFF” 6 - Ground 10 MΩ or more 100 Ω or less 10 Open circuit/ high resistance Resistance measurement • Remove the meter connector. • Key switch “OFF” 6 - Meter connector diagnosis lamp terminal 100 Ω or less 10 MΩ or more