1E-406 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 6 Check for rise of fuel level in the oil level gauge or light oil odor. Is the trouble detected? — Go to Step 7. Go to Step 8. 7 Check the connection of the fuel pipe in each injector, and replace the injector if oil leakage is confirmed. Note: For work procedure, refer to “Engine section” in the service manual. Is the procedure completed? — Go to Step 19. — 8 Is the scan tool (KW communication) available? — Go to Step 9. Go to Step 22. 9 Check the injector. 1. Clear the DTC.
Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 2. Start the engine. 3. Select the “Actuator test” from the menu. 4. Select the “Injection stop at each injector” in the “Common rail system”. 5. Press the “OFF” soft key to stop the fuel injection in the cylinder one by one, and check the change in engine sound. Is there any cylinder of which engine vibration and engine sound did not change when it is stopped? — Go to Step 10. Go to Step 11. 10 1. Replace the injector in the cylinder of which engine sound did not change when it is stopped in step 9. Note:
For work procedure, refer to “Engine section” in the service manual. Is the procedure completed? — Go to Step 20. — 11 Check the common rail pressure. 1. Turn the key switch to “ON”. 2. Check for “Common rail pressure” on the data display using scan tool. 3. Start the engine and run it at idle. 4. Check for “Common rail pressure” on the data display using scan tool. 5. Race it quickly for about 5 times. 6. Check for “Common rail pressure” on the data display using scan tool. Is each value of “Common rail pressure” (at engine stopped, idling and racing) around specified value? At engine stopping: −30 MPa (− 4351 psi); At idling, racing: ±5 MPa (±725 psi) Go to Step 18. Go to Step 12.