1E-408 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 18 1. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 2. Start the engine. 3. Select the “Actuator test” from the menu. 4. Select the “Rail pressure control” in the “Common rail system”. 5. Press the “Up” soft key to check the value of “Common rail pressure”. Is “Common rail pressure” within the specified value? ±5 MPa (±725 psi) Go to Step 20. Go to Step 19. 19 Replace the supply pump. Note: For work procedure, refer to “Engine section” in the service manual. Is the procedure completed? — Go to Step 20.
— 20 Check the DTC again. 1. Connect all the harnesses. 2. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Turn the key switch to “OFF” for more than 10 seconds. 4. Test run with the “Preconditions when DTC is set”. 5. Check the DTC. Is DTC P1093 detected? — Go to Step 2. Go to Step 21. 21 Check if other DTC is detected. Is other DTC detected? — Go to each DTC diagnosis. Verify repair. 22 Check the injector using injector checker. Refer to “How to use injector checker” in this section for how to use injector checker.
Is there any cylinder of which engine vibration and engine sound did not change when it is stopped? — Go to Step 10. Go to Step 13.