hitachi — DTC: P1094 (Flash code 226) No pump pressure feed (1st stage)

1E-412 Electronic control fuel injection system (Common rail type) EGR position sensor signal Common rail pressure sensor signal G sensor signal EGR position sensor signal EGR position sensor signal 5V Engine control module (ECM) B+ B+ B+ 98 E-56 101 E-56 82 E-56 100 E-56 90 E-56 87 E-56 92 E-56 110 E-56 93 E-56 103 E-56 94 E-56 111 E-56 5 H-20 H-20 H-20 H-20 H-20 H-8 H-8 H-8 H-8 H-8 H-8 14 6 13 12 3 7 2 6 1 5 0.5 Br 0.5 L/W 0.5 L 0.75 L 0.75 GY 0.75 W/L 0.75 G/W 0.75 W/B 0.75 G/B 0.75 W/R 0.75 L/W 1 E-80 2 E-80 6 E-80 3 E-80 7 E-80 4 E-80 8 E-80 5 E-80 0.5 L/W 0.75 B/W 0.5 L 0.5 Br 1 E-112 2 E-112 3 E-112 1 E-113 3 E-113 2 E-113 W V U EGR position sensor/EGR motor Common rail pressure sensor G sensor EGR valve TSWG0080 Description of circuit The supply pump sucks fuel from the fuel tank using the trochoid-type feed pump located inside of the supply pump.

The sucked fuel is sent through the PCV to the two plungers located inside the supply pump, and is pressurized and sent to the common rail. The PCV opening angle controls the fuel flow; if the PCV drive duty is large, the PCV opening angle becomes small resulting in less fuel flow. The ECM drives the PCV by calculating the target common rail pressure, target fuel flow, etc. based on the information from each sensor. The ECM sets the DTC when the actual fuel flow is lower than the target fuel flow, or when the common rail pressure drops sharply. Main trouble symptom Intense engine vibration Rough idling Output lowering Engine blow up fault