1E-458 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 14 1. Turn the key switch to “OFF”. 2. Remove the injector-side harness connector from the coupling connector (H-94). 3. Connect the DMM between the No. 1 cylinder injector drive circuit (H94 female- side No. 2) and the ground. 4. Turn the key switch to “ON”. Is the DMM indication specified value? 0V Go to Step 18. Go to Step 15. 15 1. Turn the key switch to “OFF”. 2. Remove the injector-side harness connector from the coupling connector (H-94). 3. Connect the DMM between the No. 2 cylinder injector drive circuit (H94 female- side No.7) and the ground. 4. Turn the key switch to “ON”.
Is the DMM indication more than the specified value? 0V Go to Step 19. Go to Step 16. 16 1. Turn the key switch to “OFF”. 2. Remove the injector-side harness connector from the coupling connector (H-94). 3. Connect the DMM between the No. 3 cylinder injector drive circuit (H94 female- side No.6) and the ground. 4. Turn the key switch to “ON”. Is the DMM indication more than the specified value? 0V Go to Step 20. Go to Step 17. 17 1. Turn the key switch to “OFF”. 2. Remove the injector-side harness connector from the coupling connector (H-94). 3. Connect the DMM between the injector power supply 1 circuit (H94 female-side No. 3) and the ground. 4. Turn the key switch to “ON”.
Is the DMM indication less than the specified value? 7.0V Go to Step 22. Go to Step 21.