Electronic control fuel injection system (Common rail type) 1E-467 Step Action Value YES NO 9 1. Check the No. 4 cylinder injector drive circuit between ECM and coupling connector (H-95) for ground short circuit using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 27. Go to Step 24. 10 1. Check the No. 5 cylinder injector drive circuit between ECM and coupling connector (H-95) for ground short circuit using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note:
If breaker box is not available, refer to “On- board check procedure for sensors”. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 27. Go to Step 24. 11 1. Check the No. 6 cylinder injector drive circuit between ECM and coupling connector (H-95) for ground short circuit using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 27. Go to Step 24. 12 1. Remove the cylinder head cover. 2. Check for installation condition of the injector harness. 3.
If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 27. Go to Step 13. 13 1. Remove the injector harnesses from the injectors of No. 4 cylinder, No. 5 cylinder, and No. 6 cylinder. 2. Measure the resistance between each injector terminal and the ground. Is the resistance more than the specified value? 10MΩ Go to Step 14. Go to Step 23.