hitachi — DTC: P1277 (Flash code 24) Accelerator sensor 1 fault (low voltage fault)

1E-482 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 5 1. Turn the key switch to “OFF”. 2. Disconnect the AP sensor connector. 3. Short between the sensor power supply terminal of the AP sensor connector and the sensor 1 signal terminal using jump cable. 4. Turn the key switch to “ON”. 5. Check for “Accelerator sensor 1” on the data display using scan tool. Is the “Accelerator sensor 1” more than the specified value? 4.8V Go to Step 8. Go to Step 6. 6 1. Check for followings in the power supply circuit between ECM and AP sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note:

If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 12. Go to Step 7. 7 1. Check for followings in the signal circuit between ECM and AP sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Short circuit to AP sensor ground circuit • Short circuit to ground • Open circuit • High resistance 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 12. Go to Step 9. 8 Replace the AP sensor.

Is the procedure completed? — Go to Step 12. — 9 Is EMPS available? — Go to Step 10. Go to Step 11.