hitachi — DTC: P1283 (Flash code 24) Accelerator sensor 2 fault (high voltage fault)

1E-498 Electronic control fuel injection system (Common rail type) About AP sensor Refer to the machine’s manual for installing position of the AP sensor. Step Action Value YES NO 11 Replace the ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 12. — 12 Check the DTC again. 1. Connect all the harnesses. 2. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3.

Turn the key switch to “OFF” for more than 10 seconds. 4. Test run with the “Preconditions when DTC is set”. 5. Check the DTC. Is DTC P1283 detected? — Go to Step 2. Go to Step 13. 13 Check if other DTC is detected. Is other DTC detected? — Go to each DTC diagnosis. Verify repair. 14 1. Turn the key switch to “ON”. 2. Check for “Accelerator sensor 2” on the data display. Is the “Accelerator sensor 2” more than the specified value? 4.9V Go to Step 15. Go to “Diagnostic aid”. 15 Check for installation condition of the AP sensor connector, ECM connector and coupling connector. 1. Check for play or looseness in the connection. 2. If the trouble is detected, repair as required.

Is the trouble detected? — Go to Step 12. Go to Step 16. 16 1. Turn the key switch to “OFF”. 2. Disconnect the AP sensor connector. 3. Turn the key switch to “ON”. 4. Check for “Accelerator sensor 2” on the data display. Is the “Accelerator sensor 2” less than the specified value? 0.1V Go to Step 8. Go to Step 6.