hitachi — DTC: P1345 (Flash code 16) Cam sensor out of phase

1E-500 Electronic control fuel injection system (Common rail type) DTC: P1345 (Flash code 16) Cam sensor out of phase Engine control module (ECM) Common rail pressure sensor signal G sensor signal 5V CKP HIGH signal CKP LOW signal 98 E-56 101 E-56 82 E-56 100 E-56 90 E-56 87 E-56 108 E-56 107 E-56 106 E-56 5 H-20 H-20 H-20 H-20 H-20 14 6 13 12 3 H-20 H-20 H-20 2 1 0.75 L 0.75 B 0.5 Br 0.5 L/W 0.5 R 0.5 G 0.5 L 0.5 L/W 0.75 B/W 0.5 L 0.5 Br 2 E-98 1 E-98 CKP sensor 1 E-112 2 E-112 3 E-112 1 E-113 3 E-113 2 E-113 Common rail pressure sensor G sensor TSWG0070 Description of circuit DTC P0335, P0336, P0340, P0341, P1345, or P1635 is not detected. G sensor pulse is normal. Crank pulse is normal.

The crankshaft position (CKP) sensor generates pulse when the tooth of the flywheel passes the sensor. Also, the G sensor, the same as CKP sensor, generates pulse when the sensing hole for signal detection installed in the supply pump camshaft gear passes the sensor. The ECM sets the DTC when the number of pulses for CKP sensor and G sensor are normal but mutual pulses do not synchronize. DTC set condition Correct G sensor pulse does not exist in crank gap position. Action taken when DTC is set Main trouble symptom Trouble is displayed on the monitor of the machine or diagnosis lamp comes on. Behavior does not change during engine running. After engine stops, engine will not start.

Preconditions when DTC is set Back-up mode Key switch input voltage is 16V or more. Engine running based on crank when it is normal