hitachi — DTC: P1345 (Flash code 16) Cam sensor out of phase

1E-502 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 4 Check the DTC again. 1. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 2. Turn the key switch to “OFF” for more than 10 seconds. 3. Test run with the “Preconditions when DTC is set”. 4. Check the DTC. • Stop the engine once, crank the engine for 4 to 5 seconds, and then check if P0340 is detected. • When DTC P0340 is detected, judge as an open circuit in G sensor, and check and repair the open circuit in G sensor. After repair, crank the engine for 10 seconds, and confirm that P0340 and P1345 disappear.

Is DTC P1345 detected? — Go to Step 5. — 5 1. Check that the camshaft gear is installed properly. 2. If the trouble is detected, repair as required. Is the procedure completed? — Go to Step 6. — 6 1. Check that the flywheel is installed properly. 2. If the trouble is detected, repair as required. Is the procedure completed? — Go to Step 7. — 7 Check the DTC again. 1. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 2. Turn the key switch to “OFF” for more than 15 seconds. 3. Test run with the “Preconditions when DTC is set”. 4. Check the DTC. Is DTC P1345 detected? — Go to Step 2. Go to Step 8.

8 Check if other DTC is detected. Is other DTC detected? — Go to each DTC diagnosis. Verify repair.