1E-514 Electronic control fuel injection system (Common rail type) DTC: P1631 (Flash code 55) Voltage fault in 5-V power supply 1 A A Engine control module (ECM) CAN HIGH CAN LOW 37 E-57 18 E-57 60 E-57 20 E-57 41 E-57 63 E-57 42 E-57 64 E-57 61 E-57 71 E-57 72 E-57 Machine control unit CAN HIGH CAN LOW 6 FL-167 5 FL-167 4 FL-167 6 FL-167 5 FL-167 4 FL-167 1 FL-269 2 FL-269 3 FL-269 2 FB-124 1 FB-124 Intake air temperature sensor Barometric pressure sensor Accelerator position sensor TSWG0081 Description of circuit DTC set condition The 5-V power supply circuit is provided to the ECM for 5 systems. The 5-V power supply circuit 1 supplies power to the accelerator position (AP) sensor.
The ECM sets the DTC when the voltage in the 5-V power supply circuit 1 is higher or lower than the normal range. Key switch power supply voltage is 5.5 V or more, or 4.5 V or less. Action taken when DTC is set Trouble is displayed on the monitor of the machine or diagnosis lamp comes on. Main trouble symptom Accelerator opening angle is controlled to 0%. Preconditions when DTC is set Back-up mode DTC P1630 is not detected. Key switch input power supply voltage is higher than 16 V but lower than 32 V. Same to accelerator sensor fault Recovery from failure Refer to “List of diagnostic trouble code” and “About recovery from failure” in this section for recovery from failure.
Accelerator Accelerator position position sensor 1 signal sensor 2 signal 5V Intake air Barometric pressure temperature sensor signal sensor signal 5V Vcc