1E-518 Electronic control fuel injection system (Common rail type) The conditions to clear the MIL/DTC Using the scan tool, or memory clear switch and diagnostic switch operation enables to clear DTCs. The present trouble turns to history trouble when the condition is out of the range from DTC set condition (recovery from failure). The diagnosis lamp will go off after the code turns to history trouble and the key switch is turned “OFF” then “ON” again. Test description Numbers below indicate step numbers in the chart. 2. Measure at the harness connector-side. 3. Measure at the harness connector-side. Step Action Value YES NO 1 Perform the OBD system check. Is the procedure completed?
— Go to Step 2. Go to “OBD system check”. 2 1. Turn the key switch to “OFF”. 2. Disconnect the barometric pressure sensor connector. 3. Connect the DMM between the barometric pressure sensor power supply terminal and the ground. 4. Turn the key switch to “ON”. Is the DMM indication more than the specified value? 5.5V Go to Step 4. Go to Step 3. 3 1. Turn the key switch to “OFF”. 2. Disconnect the barometric pressure sensor connector. 3. Connect the DMM between the barometric pressure sensor power supply terminal and the ground. 4. Turn the key switch to “ON”. Is the DMM indication less than the specified value? 4.5V Go to Step 5. Go to “Diagnostic aid”. 4 1.
Check the power supply circuit between barometric pressure sensor and ECM for short circuit to the battery power supply circuit or ignition power supply circuit using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 9. Go to Step 6.