hitachi — DTC: P1633 (Flash code 55) Voltage fault in 5-V power supply 3

1E-520 Electronic control fuel injection system (Common rail type) DTC: P1633 (Flash code 55) Voltage fault in 5-V power supply 3 (*: Specifications vary depending on each machine.

Refer to the machine’s manual.) Engine control module (ECM) Vehicle speed sensor signal Engine oil pressure sensor signal SV SV SV CKP HIGH signal CKP LOW signal Fuel temperature sensor signal Engine coolant temperature sensor signal Vcc 108 E-56 19 E-57 107 E-56 106 E-56 83 E-56 84 E-56 79 E-56 67 E-56 80 E-56 3 H-6 H-20 H-20 H-20 H-20 7 11 10 9 0.75 B/Y 0.75 L/Y 0.75 W/B 3 H-20 H-20 H-20 2 1 0.75 Y/G 0.75 B/Y 0.75 R/B 0.75 B/Y 0.75 B 2 E-93 1 E-93 1 E-90 2 E-90 1 E-76 E-76 E-76 2 3 0.5 V/W 0.5 Y Pulse matching box 2 E-98 1 E-98 Engine coolant temperature sensor Fuel temperature sensor Engine oil pressure sensor 3 E-90 CKP sensor * A 0.75 R CAN HIGH CAN LOW Engine control module (ECM) Vehicle speed sensor 37 E-57 18 E-57 4 H-6 A Meter Machine control unit Engine coolant temperature gauge CAN HIGH CAN LOW Machine trouble diagnosis monitor TSWG0078 Description of circuit DTC set condition The 5-V power supply circuit is provided to the ECM for 5 systems.

The 5-V power supply circuit 3 supplies power to the engine oil pressure sensor. The ECM sets the DTC when the voltage in the 5-V power supply circuit 3 is higher or lower than the normal range. Key switch power supply voltage is 5.5 V or more, or 4.5 V or less. Action taken when DTC is set Trouble is displayed on the monitor of the machine or diagnosis lamp comes on. Main trouble symptom Startability deteriorates at low temperatures. Black smoke emission possible Operationality is affected. Back-up mode Same to oil pressure, coolant temperature, and combustion temperature sensor fault Preconditions when DTC is set DTC P1630 is not detected.

Key switch input power supply voltage is higher than 16 V but lower than 32 V.