hitachi — DTC: P1634 (Flash code 55) Voltage fault in 5-V power supply 4

Electronic control fuel injection system (Common rail type) 1E-523 DTC: P1634 (Flash code 55) Voltage fault in 5-V power supply 4 5V Boost pressure sensor signal Engine control module (ECM) 5V Boost temperature sensor signal 74 E-56 91 E-56 E-56 95 E-56 109 15 H-20 H-20 17 8 H-20 16 H-20 0.75 B/R 0.75 R/L 0.75 R/W 0.75 R/L 0.75 L 2 E-163 E-163 1 1 E-75 2 E-75 3 E-75 Boost temperature sensor Boost pressure sensor TSWG0079 Description of circuit DTC set condition The 5-V power supply circuit is provided to the ECM for 5 systems. The 5-V power supply circuit 4 supplies power to the boost pressure sensor.

The ECM sets the DTC when the voltage in the 5-V power supply circuit 4 and 3 is higher or lower than the normal range. Key switch power supply voltage is 5.5 V or more, or 4.5 V or less. Action taken when DTC is set Trouble is displayed on the monitor of the machine or diagnosis lamp comes on. Main trouble symptom Operationality is affected. Preconditions when DTC is set Back-up mode DTC P1630 is not detected. Key switch input power supply voltage is higher than 16 V but lower than 32 V. Same to boost pressure and boost temperature sensor fault Recovery from failure Refer to “List of diagnostic trouble code” and “About recovery from failure” in this section for recovery from failure.