1E-538 Electronic control fuel injection system (Common rail type) Breaker box inspection procedure Perform the inspection in the following procedure if there is such an instruction to use breaker box in the step. After inspection, return to the diagnostic step. Name 1. Breaker box 2. DMM Step Item to be checked Inspection method Measuring condition Terminal No. Normal value Abnormal value 4 Open circuit/ high resistance Resistance measurement • Remove the machine control unit (ECU) connector.
• Key switch “OFF” 18 - Machine control unit (ECU) connector terminal 37 - Machine control unit (ECU) connector terminal 100 Ω or less 10 MΩ or more 5 Short circuit to ground Resistance measurement • Remove the machine control unit (ECU) connector. • Key switch “OFF” 18 - Ground 37 - Ground 10 MΩ or more 100 Ω or less Short circuit to power supply circuit Voltage measurement • Remove the machine control unit (ECU) connector. • Key switch “ON” 18 - Ground 37 - Ground 0V 18V or more