hitachi — Engine start failure

1E-540 Electronic control fuel injection system (Common rail type) Engine start failure Pre-inspection Exhaust system parts for fault. Before using this paragraph, perform the “OBD system check” and check all the following items. Check if excessive load is applied to the machine side. ECM and diagnosis lamp operate properly. Check the DTC. Scan tool data shows normal operating range. Check the condition of the machine to identify the applicable symptom from “List of trouble symptom”. Perform the procedure described in the symptom chart. Check with the customer if correct engine oil and fuel are used.

Diagnostic aid If the crank sensor is faulty, crank more than 60 rpm for 14 seconds or more since it is not judged on cranking for less than 14 revolutions. When the engine is running at low speed, the DTC of crank sensor fault may not be detected. If an intermittent trouble is found, raise the engine speed up to No Load Max, and check if DTC related to crank sensor is detected.

Fuel system fault (run out of fuel, frozen fuel, air mixed in fuel pipe, faulty filter [clog in main filter, gauze filter], pipe fault, fuel quality, fuel tank [foreign matter, fuel suction fault]) Intake system fault (clogging in filter, intake pipe fault, etc.) Supply pump fault (no fuel pressure feed) Common rail fault (flow damper or pressure limiter is activated, degradation of sealability) Injector fault (no fuel injection) System down due to trouble Engine body fault (seizure, compression pressure shortage, other mechanical trouble) ACG trouble Machine side related equipment trouble (oil pressure pump etc.) Effect of commercial electrical equipment (radio, lamp, etc.) ECM trouble (body, power supply, ground, etc.) Check the connector for poor contact, the harness for fault such as wear or bend, and the wire inside the harness for loosened wire causing short circuit to other circuits.

Also, perform the function diagnosis to check the operation and control of each part. Repair if faulty. Visual check Careful visual check is required for some symptom procedures. By this inspection, the problem can be corrected without performing further inspection, and time can be saved. This inspection includes the following items. There is no dirt or clogging in fuel filter. There is no poor contact in connector (it must be connected with click sound). Especially for CKP sensor and G sensor. The terminal voltage of battery is not low. Wire is connected, tightened or cut properly. Commercial accessory power supply is not bifurcated from ECM power supply.

ECM ground is not contaminated and installed to the proper position securely. Pipes and hoses relevant to fuel, air and oil are free of crack or twist, and are properly connected. Thoroughly check for any oil leakage and clogging. Fuel system is free from oil leakage, and pipe is not damaged or dent. Intake system parts for fault. Step Action Value YES NO 1 Perform the OBD system check. Is the procedure completed? — Go to Step 2. Go to “OBD system check”. 2 Check if DTC is detected. Check if following DTCs are detected. DTC: P0335, P0336, P0340, P0341, P0601, P1261, P1262 Is DTC detected? — Go to the related “Inspection method by DTC”. Go to Step 3. 3 Check the crank speed.

Check if the crank speed is more than the necessary speed for ECM to identify engine rotation. Is the crank speed more than specified value? 60 rpm Go to Step 4. Go to Step 5.