1E-542 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 8 Replace the injector in the cylinder of which engine sound did not change when it is stopped. Note: For work procedure, refer to “Engine section” in the service manual. Is the procedure completed? — — Go to Step 9. 9 Check the ACG. Check if the charge warning lamp turns on while engine is running. Note: Refer to the machine’s manual for charge warning. Does the charge warning operate? — Go to Step 11. Go to Step 10. 10 Replace the ACG. Also, check the charge warning system, and repair or replace if faulty. Is the procedure completed? — — Go to Step 11.
11 Check the condition of commercial electrical equipment such as radio and lights. Does the engine start when the commercial electrical equipment is powered OFF? — Go to Step 12. Go to Step 13. 12 Correct the installation condition of the electrical equipment, or remove the electrical equipment. Is the procedure completed? — — Go to Step 13. 13 Check the mechanical part of the engine, and repair if faulty. • Compression pressure • Valve system • Injector • Timing gear • Related part of piston/crank Note: For work procedure, refer to “Engine section” in the service manual. Is the procedure completed? — — Go to Step 14. 14 Is EMPS available? — Go to Step 15. Go to Step 16.