hitachi — Noise

Electronic control fuel injection system (Common rail type) 1E-563 Noise Pre-inspection Pipes and hoses relevant to fuel, air and oil are free of crack or twist, and are properly connected. Thoroughly check for any oil leakage and clogging. Fuel system is free from oil leakage, and pipe is not damaged or dent. Intake system parts for fault. Exhaust system parts for fault. Before using this paragraph, perform the “OBD system check” and check all the following items. Check for noise by referring to the machine’s manual. ECM and diagnosis lamp operate properly. Check the DTC. Scan tool data shows normal operating range.

Check the condition of the machine to identify the applicable symptom from the table of contents. Perform the procedure described in the symptom chart. Check with the customer if correct engine oil and fuel are used.

Diagnostic aid Fuel system fault (run out of fuel, frozen fuel, air mixed in fuel pipe, faulty filter [clog in main filter, gauze filter], pipe fault, fuel quality, fuel tank [foreign matter, fuel suction fault]) Intake system fault (EGR valve fault) Injector fault (no fuel injection) Engine body fault (seizure, compression pressure shortage, other mechanical trouble) Machine side related equipment trouble (oil pressure pump etc.) ECM trouble (body, power supply, ground, etc.) Check the connector for poor contact, the harness for fault such as wear or bend, and the wire inside the harness for loosened wire causing short circuit to other circuits.

Also, perform the function diagnosis to check the operation and control of each part. Repair if faulty. Visual check Careful visual check is required for some symptom procedures. By this inspection, the problem can be corrected without performing further inspection, and time can be saved. This inspection includes the following items. Wire is connected, tightened or cut properly. ECM ground is not contaminated and installed to the proper position securely. Step Action Value YES NO 1 Identify the source of the noise and confirm the noise. Is the noise metallic noise? — Repair or replace the faulty parts. Go to Step 2. 2 Is the scan tool available? — Go to Step 3. Go to Step 8.

3 Perform the pre-injection stop test. Select the “Stop pre-injection” from the scan tool menu to perform the test. Is there any cylinder of which engine vibration and engine sound did not change when it is stopped? — Go to Step 5. Go to Step 4. 4 Perform “Injection Stop for Each Injector”. 1. Select the “Actuator test” from the scan tool menu. 2. Select the “Injection stop at each injector” in the “Common rail system”. 3. Press the “OFF” soft key to stop the fuel injection in the cylinder one by one, and check the change in engine sound. Is there any cylinder of which engine vibration and engine sound did not change when it is stopped? — Go to Step 5. Go to Step 6.