hitachi — Oil consumption deteriorates.

1E-568 Electronic control fuel injection system (Common rail type) Oil consumption deteriorates. Pre-inspection Visual check Before using this paragraph, perform the “OBD system check” and check all the following items. Oil consumption varies depending on handling of each machine. Check Hitachi Construction Machinery's measure of oil consumption (A). Measure of oil consumption/hour Measure of oil consumption for engine alone: 4 2 {4.2qts}/100 hours Check the actual oil consumption (B). Actual oil consumption /hour Refer to the list of inspection and maintenance items of the operation manual for proper inspection depending on the operation time.

If the operation time exceeds 3000 hours, inspect by referring to the machine’s manual. ECM and diagnosis lamp operate properly. Check the DTC. Check the condition of the machine to identify the applicable symptom from the table of contents. Perform the procedure described in the symptom chart. Check with the customer if correct engine oil and fuel are used. Careful visual check is required for some symptom procedures. By this inspection, the problem can be corrected without performing further inspection, and time can be saved. This inspection includes the following items. If bluish-white smoke is emitted continuously while engine running. If blow-by gas is emitted.

If oil is mixed in the coolant. Pipes and hoses relevant to oil are free of crack or twist, and are properly connected. Thoroughly check for any oil leakage and clogging. Lubrication system is free from oil leakage, and pipe is not damaged or dent. Intake system parts for fault (turbocharger check). Diagnostic aid Intake system fault (rise/decline of oil, excessive blow-by gas) Engine body fault (oil combustion, excessive blow- by gas) Also, perform the function diagnosis to check the operation and control of each part. Repair if faulty. Step Action Value YES NO 1 Check the following for trouble occurrence:

• Engine speed • Operational pattern (continuous/intermittent) • Operating load (mode in use) • Oil consumption /hour • If more than 100 hours has elapsed since initial operation. Compare with the specified value of oil consumption by referring to the machine’s manual. Note: Use the operation mode mentioned in the machine’s manual to make comparison. Is the oil consumption within specified value? — Explain this to the customer. Go to Step 2. 2 Check for oil leakage. Repair or replace the faulty part. Is the procedure completed? — Verify repair. Go to Step 3. 3 Check if bluish-white smoke is emitted while engine running.

If it is emitted only at the starting, go to “Exhaust gas contains a lot of white smoke.” Is bluish-white smoke emitted? — Go to Step 4. Go to Step 6. 4 Check the blow-by gas quantity. Is it more than the specified value? — Go to Step 7. Go to Step 5.