Electronic control fuel injection system (Common rail type) 1E-575 List of DTC of which behavior varies depending on the machine manufacturer On some machines, the diagnosis lamp comes on instead of trouble display monitor on the machine. DTC Flash code DTC description Item to be detected Preconditions when DTC is set DTC set condition Judgment Time Behavior when trouble occurs Diagnos is lamp Recovery from failure P0107 71 Barometric pressure sensor fault (low voltage fault) Open/short circuit/ deterioration of sensor or harness • Key switch input voltage is 16V or more. • DTC P1630 or P1632 is not detected. Barometric pressure sensor voltage is lower than 0.5 V. Approx. 5 sec.
Due to back-up equivalent to 2500m (8200ft) Black smoke emitted at high altitude Output shortage at low altitude Back-up: Barometric pressure default setting (80 kPa {11.6 psi}) EGR stopped ON *2 P0108 Barometric pressure sensor fault (high voltage fault) Short circuit in sensor or harness • Key switch input voltage is 16V or more. • DTC P1630 or P1632 is not detected. Barometric pressure sensor voltage is more than 3.8 V. Approx. 5 sec. Due to back-up equivalent to 2500m (8200ft) Black smoke emitted at high altitude Output shortage at low altitude Back-up:
Barometric pressure default setting (80 kPa {11.6 psi}) EGR stopped ON *2 P0192 245 Common rail pressure sensor fault (low voltage fault) Short circuit in sensor or harness • Key switch input voltage is 16V or more. • DTC P1630 or P1635 is not detected. Common rail pressure sensor voltage is less than 0.7 V. Nearly simultan eous to fault occurren ce Engine blow up Back-up: Actual rail pressure default setting (80 MPa {11603 psi}) Rail pressure feedback control stopped Limited injection amount 2 (multi- injection stopped) ON *2 P0193 Common rail pressure sensor fault (high voltage fault) Open/short circuit/ breakage of sensor or harness • Key switch input voltage is 16V or more.
• DTC P1630 or P1635 is not detected. Common rail pressure sensor voltage is more than 4.5 V. Nearly simultan eous to fault occurren ce Output lowering, Black smoke emitted Engine stall possible Back-up: Actual rail pressure default setting (80 MPa {11603 psi}) Rail pressure feedback control stopped Limited injection amount 2 (multi- injection stopped) ON *2 P0201 271 Open circuit in injection nozzle #1 drive system Open/short circuit in electrical wiring No. 1 cylinder injector • Main relay power supply voltage is 16V or more. • 70 rpm or more • DTC P0611, P1261 or P0201 is not detected. No injector 1 monitor input signal exists. Approx. 3 sec.
Intensive engine vibration, rough idling, output lowering, blow up fault Back-up: Injection for cylinder #5 stopped ON *1