hitachi — Service Precautions

1B-2 Engine Mechanical (6WG1 (Common rail)) 6WG1-TC Engine Service Precautions Precautions on specialized work for this engine The holes and clearances that form part of the fuel supply lines inside the injectors and other parts of the fuel system have been made to a very precise standard. The system is therefore highly sensitive to dust particles, and dust particles getting into the system may cause the vehicle to breakdown while on the road. For that reason, you should aim to completely prevent any dust particles from getting into the system.

In order to prevent damage to the engine and to guarantee the reliability of engine performance, pay close attention to the following points when performing engine maintenance. Do not put the jack on the oil pan when lifting or supporting the engine. When lowering the engine onto a base, use an engine pallet or wooden frame and rest the engine on the engine foot and flywheel housing. When removing the intake system, cover the intake port to prevent dust particles from getting into the cylinder. If dust particles get into the cylinders, they can cause a large amount of damage to cylinders etc. when the engine is running.

Always remove the battery earth cable when performing maintenance work on the main engine body. Be careful not to cause short circuits etc. when performing inspections or other such work that requires the electricity flow to be connected. In order to protect and lubricate the sliding surfaces during the first stage of the engine's life, ensure that enough engine oil is applied to all sliding surfaces. When removing parts surrounding the valves, pistons, piston rings, connecting rods, connecting rod bearings, and crankshaft journal bearings, arrange and keep the removed parts in order. When re-installing the parts, install the same part to the same position it was in when it was removed.

Every time gaskets, oil seals, O-rings and other such parts are disassembled, they should always be replaced with brand new parts. When using liquid gasket, make sure that all of the old liquid gasket is completely removed, clean the parts so that there is no oil, fat, water, or dirt on any of the surfaces, and apply the specified type of liquid gasket when re-assembling the parts. Install these parts within 7 minutes of applying the liquid gasket. If more than 7 minutes passes, remove the previous liquid gasket and re-apply a new layer. When assembling or installing parts, tighten bolts to the appropriate tightening torque, and perform all part fitting work correctly.