hitachi — Removal

Engine Mechanical (6WG1 (Common rail)) 1B-27 31. Remove the fuel filter from the bracket. Important: Hang a spanner on the common rail flow dumper (2 side width 19mm) and rotate and stop it, then loosen the injection pipe sleeve nut. Seal the pipe and pump to prevent dust particles from getting in. Take care not to damage the shape of the injection pipe when removing it. Furthermore, a small amount of oil may spill from the head section, which should be cleaned with a rag etc. Check that there are no cracks or damage to the clip rubber. Important: Seal the installation sections of the removed pipe to prevent it from becoming dirty. Legend 1. Fuel pipe (IN) 2. Fuel pipe (OUT) 3.

Fuel pipe (OVER FLOW) 4. Fuel filter 32. Remove the fuel pipe (supply pump ~ common rail). Legend 1. Injection pipe No.1 2. Injection pipe No.2 3. Injection pipe No.3 4. Injection pipe No.4 5. Injection pipe No.5 6. Injection pipe No.6 34. Remove the fuel pipe clip BRKT and remove the common rail. Important: Seal the common rail installation opening to prevent it from becoming dirty. Legend 1. Fuel pipe (supply pump ~ common rail) 2. Common rail 3. Supply pump 33. Release the injection pipe clips and remove the injection pipe.