Engine Mechanical (6WG1 (Common rail)) 1B-43 39. Install the cooler water pipe for the EGR cooler and rubber hose (feed side) and fix it with clips. Install the engine harness as shown in figure (1), then fix it with clips in the position marked when it was disassembled. Legend 1. Rubber hose 2. Rubber hose 3. Water pipe for EGR cooler (LH) (feed side) 4. Rubber hose 5. Clip 6. Water pipe for EGR cooler (FT) (feed side) 7. Clip 40. Install the oil level gauge guide tube. Apply a thin coating of oil to the O-ring, and insert it carefully without damaging it. Legend 1. Oil level gauge 2. Guide tube 3. Stay 4. Stay 41. Install the engine harness.