hitachi — Removal

Engine Mechanical (6WG1 (Common rail)) 1B-79 The oil seal cannot be re-used. Backlash (mm) Use a remover to remove the slinger. The slinger cannot be re-used. Caution: When replacing the oil seal, always replace the slinger together as a set. If the remover separates easily from the slinger, tightening the jig's perimeter with a clip band to makes it easier to remove the slinger. Measure the idle gear A shaft orientation clearance. Remover; Slinger: 1-8521-0027-0 Shaft orientation clearances (mm) Measure the idle gear B shaft orientation clearance. Shaft orientation clearances (mm) 6. Remove the oil pump. 7. Remove the O-ring for the oil pump. 8. Remove the distance bolt. 9.

Remove idle gear A and idle gear B. Before removing the idle gear, measure each idle gear backlash. Standard Limit 0.060 ~ 0.095 0.23 Standard Limit 0.165 ~ 0.230 0.35 Standard Limit 0.050 ~ 0.140 0.25