hitachi — ID code download (Tech2)

1E-66 Electronic control fuel injection system (Common rail type) Step 12-2 The following display appears when the engine speed is not 0 rpm. In this case, stop the engine as instructed in the message, and try again from Step 1. Step 13-1 Registration is started from No. 1 cylinder (INJ.#1) to No. 2 cylinder (INJ.#5) and the ECM in the order. The status for registration (writing) of data to ECM will appear. The message in the screen changes in the order of No. 1 cylinder (INJ.#1) and No. 2 cylinder (INJ.#5). When it is abnormal, the registration repeats 3 times. TSHK0092 Step 13 Pressing the softkey [Yes] downloads (registers) the uploaded ID codes (Cyl.1-Cyl.6) to the ECM.

Pressing the softkey [No] returns you to Step 11. Download is the function to register (write) the stored (uploaded) ID codes (No. 1 cylinder No. 6 cylinder) in the Tech2 to the ECM. ID is registered from No. 1 cylinder to No. 6 cylinder in the order. TSHK0094 Step 13-2 When the downloaded ID code corresponds to that registered (written) in the ECM, the following message will appear. Download (registration) is completed. Pressing the softkey [Confirm] returns you to Step 11. TSHK0093 TSHK0095