1D-2 Fuel system (6WG1 (Common rail)) Fuel system Service Precautions 2. The fuel pipes and injection pipes should also be handled as in 1. above. 3. It is also important to keep parts used in installing fuel pipes such as eyebolts or gaskets in covered clean parts boxes so that they do not become dusty. Furthermore, the parts boxes should be cleaned regularly. 4. When handling the parts, using rubber gloves or ones bare hands is most desirable. If it is absolutely necessary, working gloves can be used, but they should be constantly checked for dirt or dust, and brand new gloves should be used if possible. 5.
Spilt fuel can cause fire, so after completing work make sure that any spilt fuel is completely wiped up, and always check that there are no fuel leaks after starting the engine. Precautionary notes on the handling of fuel related parts The electronic control fuel-injection system (common rail type) achieves a far higher injection pressure and far higher level of control than conventional systems. For this reason, all parts of the fuel supply lines from the injector internal sections to the holes and clearance sections have been made to an exceptionally precise standard.
The sensitivity to dust particles is therefore also far higher than in the past, and because the inclusion of dust into the fuel system can cause fatal injury or breakdown on the road, thorough measures must be taken to prevent dust from entering the fuel system. Work outline 1. When removing the injector, supply pump or common rail, the fuel opening must be quickly sealed. Explanation of functions and operations Fuel system diagram Legend 1. Common rail 2. Fuel filter 3. Injector 4. Fuel tank 5. Feed pump 6. Supply pump 7. Feed line 8. Return line