hitachi — How to display snapshot

1E-70 Electronic control fuel injection system (Common rail type) 11. On the “TIS 2000 Update” screen, click the “OK”. This describes about how to transmit and display Tech2 snapshot data using the “Snapshot Upload” function of TIS 2000. Snapshot data can be displayed with the “Snapshot Upload” function of TIS 2000. The trouble symptom can be checked by analyzing snapshot data with various methods. To display the snapshot data, perform the following 3 steps; A. Record the snapshot data in Tech2. B. Transmit the snapshot data to PC. After recording the snapshot data to Tech2, transmit the data from Tech2 to PC in the following procedure. 1. Startup TIS 2000. 2.

Choose the “Snapshot Upload/Display” on the initial screen of TIS 2000. 3. Either select the “Upload from diagnostic tool” or click the appropriate icon on the tool bar. 4. Select the “Tech2” and transmit the saved snapshot data. 5. Select the “Transmitted Snapshot”. 6. When the snapshot data transmission is completed, the data parameter list will appear on the screen. 12. If the installation is completed, the “TIS 2000” icon is displayed on the desktop. * An error message may appear when restarting the PC at Step 12. In this case, install the following file in the CD- ROM.

~cosidsҐDiagҐMdac_type.ex_ Copy this file on your hard disk, change the file name into “mdac.exe”, and double-click “mdac.exe”. After this work, install TIS 2000 again. How to display snapshot Fig. 2: Data display (sample) Fig. 1: “Application Selection” screen