hitachi — Explanation of functions and operations

1E-2 Electric system (6WG1 (Common rail)) Starting system Service Precautions Cautions when handling parts If the gap between the pinion and ring gear is inadequate, the engagement will become bad. (Gap 2 ~ 5 mm) Also, firmly fix the front bracket to the engine side when installing it. Always turn off the battery switch before removing or installing the starter. Always firmly install or insert electrical wiring. If the wiring is not firmly installed/inserted, contact resistance increases and starting difficulties may occur. Cautions when starting Pay attention to the battery's charge condition. A lack of charge can cause starting difficulties.

Once you have confirmed the engine has started, promptly switch off the starter switch. The continuous use time limit is 10 seconds per time. Wait until the pinion has completely stopped before restarting the engine. If the starter switch is switched off but the starter doesn't stop revolving, promptly switch off the battery switch. In this situation, inspect the electrical wiring, switches etc. Explanation of functions and operations Schematics (Made by Mitsubishi)