hitachi — Assembly

Lubricating system (6WG1 (Common rail)) 1H-5 Oil filter Component parts Legend 1. Body 2. Nipple 3. Cartridge oil filter 4. Splicing fittings (machine side components) Disassembly Assembly The oil filter is not installed to the engine by a sub oil filter (machine side Installation) 1. Use a filter wrench to remove the cartridge filter. 1. Set the body. 2. Apply Loctite to the nipple and install it. 3. Install the cartridge oil filter. Apply engine oil to the O-ring section of the cartridge oil filter, screw the nipple into the body, and tighten to the correct tightening torque.

If you use the filter wrench shown in the diagram below and tighten with a torque wrench, the torque must be converted. Wrench; Main filter: 8-9801-3170-0 2. Remove the nipple. If there are no problems with the screw thread of the nipple screw, do not remove it. 3. Clean the oil lines within the body.