1E-76 Electronic control fuel injection system (Common rail type) Standard update (This mode is not used this time. Select the “Custom”.) Description: Standard mode can be used only when the old version of software is installed and registered in the database. Only “Custom” mode can be used in any other cases. In “Standard” mode, the latest version will be installed for the language and the model (manufacturer) which are set in Tech2 at that time. 8. When the transmission is completed, “Transmission is completed” will appear on the screen. Click the “Close” button to quit the application. The latest software has been transmitted to the diagnostic tool.
Custom update Use custom update when installing the old version software, software other than Isuzu software or software with different language, or when the database cannot identify the software version being installed. After selecting “Custom” on the selection screen (See Fig. 2), perform the following procedure. The procedure of Tech2 “Standard” update, using “Software Download” function, is as follows. 1. Connect the Tech2 to the PC with RS-232C cable. 2. Connect the standard accessory power cable to Tech2. 3. Startup TIS 2000 on the PC. 4. Choose “Software Download” icon on the initial screen of TIS 2000. 5.
Check the selected location on the “Select Diagnostic Tool for Download” screen, and go to next. 1. The “Application Selection” appears on the screen. The list of the software release No. appears on the left hand of the screen. Clicking [+] mark allows to view the list of available language of each release. Fig. 3: Selection of application for “Custom” mode 2. Either double-click the relevant software version and language, or click the “Select” button to select. The software you have chosen appears on the right hand of the screen. To compare current software with selected software of the diagnostic tool, click the mark on the right hand of the screen. 3.
Clicking the [Download] button starts updating. 4. “Transmitting Software” appears on the screen to tell the transmission status. 5. When the transmission completes, “Transmission is completed” will appear on the screen. Click the “Close” button to quit the application. The selected software has been transmitted to the diagnostic tool. Fig. 2: Selection of diagnostic tool to be updated and update mode Check the selected location and click “Next”. An explanation appears as “Reading information of diagnostic tool”. 6. The “Software Update Confirmation” screen appears on the PC.
Also, the stored contents of the current Tech2 and stored data after transmitting diagnostic software appear on the screen. Click the [Continue] to go on. 7. “Transmitting Software” appears on the screen to tell the transmission status.