1J-4 Intake system (6WG1 (Common rail)) If faults or vibrations occur Condition Probable cause Correction If faults or vibrations occur The cause is bearing failure and contact between the revolving section and its surroundings Bearing failure is caused by: Neglecting oil changes, dust particles in the feed pipe, clogged oil filter, driving when the engine has a failure, and repeated sudden starts and stops. Inspection and repair If there are no faults in the lubricating system, and damage due to the revolving section making contact with its surroundings is discovered, it is possible to assume that either a loss of balance in the revolving section or bent shaft is the cause.
This is probably because a worn-out bearing was used, or because dust particles have gotten into the turbine wheel or compressor wheel and caused damage Inspection and repair