Preheating system (6WG1 (Common rail)) 1K-3 Functional check QOS II Inspection and adjustment 1. Thermo sensor inspection The sensor Installation position is on the left side of the cylinder head. 2. Glow plug inspection Use a circuit tester to measure the resistance value of the glow plugs. Replace the glow plugs if the measured results are different to the stipulated values. Glow plug resistance value = approx 4.3 Ω (room temperature) Caution: Always use a set of 6 glow plugs from the same manufacturer. Name 1. Intake manifold 2.
Sensor Put the temperature sensing element of the sensor into water, and check that the resistance value changes with the change in water temperature as shown in the graph. Sensor and temperature resistance values (for engine control) Temperature (°C) Resistance value (kΩ) 90 0.247 100 0.190 110 0.148 Temperature (°C) Resistance value (kΩ) - 10 9.20 20 2.50 50 0.84