Komatsu — 9 - Check whether the work unit is completely locked in by tipping it in and then dumping it.

OPERATING THE MACHINE 20. OPERATING THE MACHINE 20.1 PREPARING THE WORK EQUIPMENT 20.1.1 SELECTING A WORK UNIT Refer to chapter "7. Equipment" for information on the work units registered. 20.1.2 PICKING UP THE WORK UNIT (EXCEPT MULTI-PURPOSE BUCKET) Connect the multi-purpose bucket as described in section „Pick- ing up the multi-purpose bucket“ (see next page). 1 - Make sure that the change-over lever for the additional con- trol unit is in position '2' (fig. 75_160). 2 - Start the engine. 3 - Unlock the quick-change unit by setting the control lever for special equipment into position ‘1’ (fig. 75_042). 4 - Lift the boom slightly by setting the multi-function lever into position ‘H’ (fig.

75_016). 5 - Tilt the quick-change unit slightly to the front by setting the multi-function lever into position 'A' (fig. 75_016). 6 - Drive the machine to the work unit until the quick-change unit (3) is below the pickup hooks of the work unit. Then, lift the boom until the work unit catches the quick-change unit (fig. 75_280). 7 - Tip in the quick-change unit until the work unit is connected to the limit stops on the the quick-change unit by setting the multi-function lever into position ‘E’ (fig. 75_016). 8 - Lock the quick-change unit by setting the control lever for special equipment into position ‘2’ (fig. 75_042). The interlocking pins (4) will then be visible (fig. 75_280).

2 1 75_160 3 2 0 1 75_042 3 4 75_280 90 75 016 _