MAINTENANCE PROCEDURE BLEEDING THE CIRCUIT After filling the tank, turn the ignition key to position « » and wait for approximately 15-20 seconds, in such a way as to ble- ed the fuel supply circuit. IMPORTANT q After bleeding the circuit, turn the ignition key to posi- tion « » for a few seconds and wait at least 2 minutes before starting the engine. q If the engine starts without problems and then stops or works irregularly, check if there is air in the circuit; if so, check the tightness of the fuel filter and of the fuel pump prefilter. RWA01960 q After the fuel has run out, bleed the circuit by proceed- ing as described above and repeat the operation for at least 2-3 times. RWA01970 193