Komatsu — 6.2.5 USING THE MACHINE WITH THE EXCAVATOR

CHANGING THE AUTHORIZED EQUIPMENT 6.2.4 PREPARING THE MACHINE FOR THE USE OF THE EXCAVATOR After the installation of the excavator, make sure that the mechanical and hydraulic connections have been carried out correctly and proceed as follows. 1 - Press the auxiliary kit control pedal with your toe until en- gaging it in position (B); this position ensures the flow of oil to the equipment. 2 - For the use of the excavator, see the specific instruction manual. 3 - If the machine is equipped with rear stabilizers, lower them until the rear wheels are partially raised; this ma- noeuvre stabilizes the machine and avoids any tyre over- load (see "3.3.5 pos.

13 - RIGHT STABILIZER CONTROL (IF INSTALLED)" e pos. 14 - LEFT STABILIZER CON- TROL (IF INSTALLED)"). 6.2.5 USING THE MACHINE WITH THE EXCAVATOR q Before using the excavator, read the relevant operation and maintenance manual carefully and keep to the instructions contained therein. q If the machine is equipped with rear stabilizers, always lower them before using the excavator. q After the digging operation and before moving the machine, bring the stabilizers back to their original position. q If it is necessary to travel on roads, engage all the safety locks provided. See "3.1 SAFETY LOCKS". 222 WARNING