HAND & FOOT CONTROL SYSTEM 6.5.1.1 TRAVEL AND STEERING CONTROL LEVERS q Before carrying out any manoeuvre with the levers, the operator must be seated in driving position with fastened safety belt and lowered safety bars; before any manoeuvre it is important to take all the precau- tions indicated in "6.5.2 HOW TO MOVE THE MACHINE (HAND & FOOT CONTROL SYSTEM)". q Before moving the machine, make sure that the parking brake is released. q When travelling on roads, always inhibit the equipment control (see "3.3.5 pos. 8 - EQUIPMENT CON- TROL LOCKING LEVER (IF INSTALLED)"). q When travelling on roads, always make sure that all safety locks are engaged.
q Before leaving the operator seat, stop the engine only after lowering the equipment to the ground and locking the controls (safety bars lifted in vertical position). q Non-compliance with these rules may lead to serious accidents. The travel control levers (1) and (2) are positioned on the Op- erator's left and right side, respectively, and they control the forward and reverse travel of the machine according to the movements shown in the diagram. IMPORTANT q To move the machine forward or in reverse, shift the le- vers (1) and (2) at the same time and in the same direc- tion. q For further details on the use of the levers, see pos.
6.5.2 HOW TO MOVE THE MACHINE (HAND & FOOT CONTROL SYSTEM)" N - Neutral A - Forward B - Reverse 228 WARNING A A N N B B RKA10420