MAN — Removing and installing piston with connecting rod

Removing and installing piston with connecting rod Fig. 9 Put connecting rod bearing caps in place. Caution: The numbers on the connecting rod bea- ring cap and connecting rod big end must be on one side. 10 3560 Fig. 10 Screw in connecting rod bearing bolts and tighten them in stages to specified value. Tighten finally by angle. (For tightening torques and reusability of bolts, see ”Engineering S Data S Setting values”.) 10 3726 Fig. 11 Slowly turn engine over. Connecting rods and oil spray nozzles (arrow) must not collide or grind against each other. 11 3462 102