Replacing cylinder liners Installing cylinder liners Fig. 6 Insert dry new O-rings for the lower seal (144x4) into the crankcase. Fig. 7 Insert new O-rings for the upper seal (138x2) into the grooves on the cylinder liner. Do not overstretch the O-rings. 6 3574 Fig. 8 Apply thin coat of engine oil to cylinder liner in the area of the upper and lower O-ring. Apply thin coat of engine oil to lower O-rings in the crankcase. Insert cylinder liners into crankcase and push them down by hand. Place clean metal plate on liner and exert uniform downward pressure until the liner is seated in the crankcase recess.
If a perceptible resistance can be felt in this oper- ation, the O-rings are no longer in their proper place. Reposition O-rings and insert cylinder liner again. 7 3575 Note: No grease or sealing agents of any kind must be used for installing cylinder liners and O-rings. Note: After fitting the cylinderliners ensure that the O-rings are in the correct posi- tion by checking the liner protrusion with special tool. Use special tool, see page 130 as follows: Position press-on measuring plate with turned collar facing the liner using 2 fit- ting sleeves to centre plate. Tighten 4 bolts (improvised:
collar bolt 51.90020-0270, length shortened to 90 mm) on the press-on measuring plate in stages and crosswise to 40 Nm. Set dial gauge combination above press-on plate to “0” under preload rela- tive to the crankcase. Measure cylinder liner protrusion at least at four points. 8 3576 109