Trouble shooting table 14 Engine does not run smoothly, and stops D Lower idle speed set too low D Air in fuel system D Fuel lines leaky, ruptured, clogged D Fuel filter clogged D Inlet chamber pressure of injection pump too low D Fuel high-pressure part leaky D Injector needle sticking D Delivery start set incorrectly D Injection pump set incorrectly or defective D Valve clearance incorrect D Compression insufficient Speed fluctuations dur- ing operation Slow, periodic oscillating of speed (approx. 0.5 − 1 Hz) Quick periodic oscillating of speed (approx.
8 − 12 Hz) D Air in fuel system D Fuel lines leaky D Fuel high-pressure part leaky D Injection nozzles defective, worn D Excessive friction in power transmission ”final controlling element − linkage − control rod” D Battery voltage too low D Force of final controlling element too low D Setting of the D proportion too small D Setting of the D proportion too large D Resonance vibrations in the drive / clutch D Exchange final controlling el- ement D See description of control unit D See description of control unit D Reduce sensitivity; see descrip- tion of control unit Engine cannot be switched off D ”Final controlling element − control rod” transmission stiff / blocked Performance unsatis- factory D Engine speed adjusting lever not in full-load position D Fuel temperature too high D Unsuitable, contaminated fuel D Fuel filter clogged D Air in fuel system D Lack of fuel D Temperature in engine room too high, combustion air and fuel too hot D Supply of combustion air insufficient, intake vacuum too high D Charge-air pipes leaky D Intercooler contaminated D Turbocharger contaminated or defective D Compression insufficient D Injection pump defective D Route the fuel lines well apart from the hot engine parts D See ”Fuels, Lubricants ...” D Check fuel lines and delivery pump D Check inward and outward ven- tilation D Check intake air supply to air filters