MAN — Removing and installing thermostat

Removing and installing thermostat Fig. 1 D Drain coolant, see page 38 Remove coolant neck from water pump. 1 4309 Fig. 2 Take out thermostat insert. Check the function of the thermostat insert as fol- lows. D Hang thermostat in a pot filled with water D Heat water D Use suitable thermometer to ascertain the opening start and compare it with the set−point value given in ”Engineering S Data S Setting val- ues”. D Measure opening stroke if necessary. Exchange defective thermostats. 2 4311 Fig. 3 Insert thermostat inserts (ball valve facing upwards (”TOP”) with new O-ring seal and new seal. Caution: Never let engine run without thermostats. 3 4310 40