Oil pump Disassembling and assembling oil pump Fig. 4 Clamp oil pump in a vice (fitted with soft jaws). Re- move oil pump cover (13 mm). 4 3669 Fig. 5 Pull driven oil pump gears out of the housing. Check gears and pump housing for wear (see ”Engineering S Data S Setting values”). 5 3458 Fig. 6 Remove oil pump drive gear. To do this, lay pump on suitable support and press off drive gear using a mandrel. Place drive gear on the shaft and press it into place. Thereby support opposite shaft end. Pres- sing force see ”Engineering S Data S Setting va- lues”. 6 3459 Checking axial play of the pump gears Fig.
7 Position dial gauge and push shaft up to the stop in one direction and set dial gauge to “0”. Push shaft in opposite direction and read the movement from the dial gauge. 7 3582 52