Checking the charge-air pressure Checking charge-air pressure Sufficient charge-air pressure is indispensable for full power output and clean combustion. Checking the charge-air pressure helps detect damage to the turbocharger, operating faults in the waste- gate and leaks in the intercooler and in the charge-air pipes. Extreme operating conditions (full-load operation and high air temperature) and the use of unsuitable en- gine oils (also see publication ”Fuels, Lubricants, Coolants for Industrial and Marine Diesel Engines”) may cause deposits on the compressor as well as in the intercooler, which results in a reduction in charge-air pressure.
Preconditions for the measurement The delivery start and the valve clearance must be set as specified, and the engine must be at operating temperature. Charge-air pressure: A general set-point value for the charge-air pressure cannot be given. Values ascertained on the test bed ought not to be used for comparison, as the respective installation conditions are decisive. The value which was ascertained during commissioning and was noted in the commissioning report is to be used as the set- point value. When carrying out the measurement, observe the following:
Owing to various atmospheric reference conditions during the measurements and to tolerances of the pres- sure gauges used, deviations of max. ± 100 hPa ( ± 100 mbar) are permissible. Fig. 1 A measuring connection for checking the charge- air pressure and the charge-air temperature is lo- cated in the intake manifold behind the intercooler. Remove screw plug (M32x1.5). Connect up pressure gauge (if necessary using a suitable threaded pipe as adapter). 1 4372 Fig. 2 Measure the charge-air pressure downstream of the intercooler at nominal engine speed and full load. 2 4373 70