MAN — Setting valve clearance

Setting valve clearance Fig. 1 Remove cylinder head cover (13mm). Note: On engines recently manufactured the valve covers are fastened with Torx bolts for which an E12 − 1/2” wrench is re- quired. 1 4279 Fig. 2 The speed pickup is fitted to the bottom right−hand side of the flywheel housing. Remove the mounting bolts from the retaining plate and take it off to- gether with the speed pickup. Fit cranking device (standard ratchet, special tool). 2 4278 Figs. 3 Use barring device to turn engine so that the pis- ton in the cylinder to be set is at TDC and the two valves are closed. At this point both inlet and ex- haust valves will be open i. e. valves overlap.

Valves are in crossover in cylinder Set valves in cylinder 3 4276 Fig. 4 Arrangement of cylinders and valves I II I Engine front end II Flywheel side A Exhaust valve E Inlet valve 4 3607 79 1 5 3 6 2 4 6 2 4 1 5 3 1 E A 2 E A 3 E A 4 E A 5 E A 6 E A