MAN — Removing and installing valves

Removing and installing valves Installing valves Fig. 5 Apply oil to valve stern and insert valves into valve guides. Note: Minor damage to the valve seat can be eliminated by lapping using valve lapping paste. New valves must always be lapped until an even valve seat has been achieved. Machine valve seat insert if nec- essary. 5 3530 Turn cylinder head over and insert valve spring washers. Screw off valve assembly lever. Figs. 6 and 7 Place insert sleeve for valve shaft seals (special tool, see page 128, item 19) on the respective valve and push on seal. Note: Use new valve shaft seals only. 6 3752 7 3753 Fig. 8 Take off insert sleeve. Fit press-in sleeve and press in seal. 8 3754 83