OWNER 爷 S MANUAL JAC HEAVY DUTY TRUCK WINDSHIELD WASHER OPERATION EXHAUST BRAKE SWITCH To use the windshield washer, press in on the button on the end of the wiper/ To use the exhaust brake, put the "ON' position. The exhaust brake operates washer lever. When the washer button is pressed, the wipers automatically when you remove your foot from the accelerator pedal and the clutch pedal. make two passes across the windshield, And the windshield wiper is operated 2 to 3 times at the same time, The washer continues to operate as long as the The exhaust brake will not operate automatically if you operate the accelerator pedal or the clutch pedal. button is depressed.
Use exhaust brake when going down a slope. CAUTION: 荫 Do not use the wiper when the windshield is dry. 荫 The washer button should not be pressed if the washer reservoir is empty. This can damage the washer fluid pump. Do not operate the washer for more HAZARD WARNING The hazard warning lamp should be used whenever you find it necessary to than 15 seconds at a time. stop the car in a hazardous location. When you must make such an emergen 鄄 cy stop, always pull off the road as far as possible. The hazard warning lights are turned on by pushing in on the hazard switch . This causes all turn signal lights to blink.
The hazard warning lights will oper 鄄 ate even though the key is not in the ignition. To turn the hazard warning lights off, push in on the switch a second time. 40 41