PERIODIC SERVICE 16 ENGLISH B Replacing the oil filter cartridge RADIATOR Coolant will last for one day's work if filled all the way up before operation start. Make it a rule to check the coolant level before every operation. To avoid personal injury: A Be sure to stop the engine before changing the oil filter cartridge. A Allow engine to cool down sufficiently, oil can be hot and cause burns. To avoid personal injury: A Do not stop the engine suddenly, stop it after about 5 minutes of unloaded idling. A Work only after letting the engine and radiator cool off completely (more than 30 minutes after it has been stopped). A Do not remove the radiator cap while coolant is hot.
When cool to the touch, rotate cap to the first stop to allow excess pressure to escape. Then remove cap completely. If overheats should occur, steam may gush out from the radiator or recovery tank; Severe burns could result. 1. Replace the oil filter cartridge. Oil filter cartridge should be replaced, as following operation hours. * 90 mm (3.54 in.) oil pan depth is optional. 2. Remove the old oil filter cartridge with a filter wrench. 3. Apply a film of oil to the gasket for the new cartridge. 4. Screw in the cartridge by hand. When the gasket contacts the seal surface, tighten the cartridge enough by hand. Because, if you tighten the cartridge with a wrench, it will be tightened too much.
(1) Oil filter cartridge (2) Remove with a filter wrench (Tighten with your hand) 5. After the new cartridge has been replaced, the engine oil level normally decreases a little. Thus, run the engine for a while and check for oil leaks through the seal before checking the engine oil level. Add oil if necessary. A Wipe off any oil sticking to the machine completely. Models Oil pan depth 124 mm (4.88 in.) *90 mm (3.54 in.) D1503-M-E D1703-M-E D1803-M-E V2003-M-E V2203-M-E V2003-M-T-E V2403-M-E 200 Hrs 150 Hrs Initial 50 Hrs